A custom fiber assembly should arrive with the details your installation actually needs. The most useful starting point is a clear end-to-end specification: what equipment it connects, where it runs, and how the installer will place it.
Use this checklist to turn drawings and equipment requirements into an assembly request that is easier to review, quote, and approve.
Start with the link requirements
Record the equipment at both ends and the optical interface each device requires. Confirm the specified fiber mode with your designer or equipment documentation. Singlemode and multimode are not interchangeable choices, and selecting a fiber category alone does not establish the supported distance of the complete link.
Next, list the fiber count. Separate the fibers needed on day one from spare capacity required by the project. Make sure the enclosure, adapter configuration, and termination plan accommodate that total.
Write down both ends separately
A request for “LC connectors” leaves important questions open. Identify connector type, polish, quantity, and breakout arrangement for End A and End B. If the ends differ, label them clearly on the drawing. Confirm the required fiber mapping or polarity with the equipment and patching plan.
Match the cable to the actual route
Describe indoor and outdoor portions, pathway conditions, and the jacket rating shown on the project specification. If armor is required, include that requirement explicitly. The cable construction and its listing need to suit the application; a general product family name is not a substitute for the exact cable specification.
Confirm length and installation protection
Measure the planned route, including vertical transitions, cabinet entry, and approved service slack. Ask how the assembly manufacturer measures overall length and breakout length. Identify which end leads the pull and confirm the pulling-eye or protection arrangement before ordering.
- Fiber mode and count
- End A and End B connector details
- Jacket rating and cable construction
- Overall length, breakout lengths, and length convention
- Pulling protection, labels, and required test documentation
- Quantity, project reference, and requested delivery date
Approve one complete configuration
Keep the approved assembly drawing or written configuration with the purchase order. If a connector, route, or cabinet changes, review the whole configuration again. Resolving those details before fabrication is easier than discovering a mismatch when the crew is ready to install.
Put your next step in motion
Browse Telecom Specialties custom pre-terminated fiber assemblies and choose the configuration that matches your approved requirements. Explore the options, or send your requirements to our team.
